Magic LED T8 tube
Brief Description:
The Magic T8 LED tube achieving UL, ETL which can work with specific T8 electronic start ballast.This T8 tube also can work without ballast but wire directly to AC100-277V input.
Advantages of the Magic LED T8 Tube:
-
This tube can work both with ballast or without ballast. So it is fantastic direct replacement tube as well as retrofit kit.
-
Compatible with most than 90 percent electronic ballast in North American market.
-
The wattages and Lumens for the tube itself work with ballast and without ballast are same so it is good for big project which has different type of ballast.
-
Input voltage can be AC100-277V with ballast and AC100-277 without ballast.
-
Reduces energy consumption up to 40%.
-
No UV emission.
-
Suitable for dry and damp environments.
-
T8 housing available.
-
UL and ETL Qualified.
Product Specification:
Technical Specification:
Ordering Guide:
Installation Procedure:
“Plug” and “Play” procedure
-
Turn off the power to the light fixture at the breaker panel before installation.
-
Open the diffuser from the light fixture.
-
Remove the fluorescent tubes.Please dispose of these items properly as they contain mercury.
-
Put led tube into the lighting fixture.
5. Install the LED tubes,close the diffuser.
6. Turn on the Power
Retrofit Procedure
-
Turn off the power to the light fixture at the breaker panel before installation.
-
Open the diffuser from the light fixture.
-
Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury.
-
Cut the wires as shown in the diagram below
5. Make the new wire connect to branch circuit shown as the diagram below.
6. Replace the cover over the wiring channel..
7. Install the LED tubes, close the diffuser
8. Turn on the Power.
For one ballast by three fluorescent tubes fixture, at least need to put two pieces of ballast compatible tube.
For one ballast by four fluorescent tubes fixture, at least need to put three pieces of ballast compatible tube.